Our Single Axis Accelerometer allows you to determine just how many G forces you are pulling off of the starting line. For those racers that are pushing their performance to the peak, being able to track whether a setup change actually caused the car to launch harder is critical. With this G meter, you can easily see your g forces represented in a graph.
Robust shock travel sensor for monitoring suspension.This Shock Travel Sensor is available in a 4″ and 8″ lengths and is one of the strongest shock travel sensors we have found on the market. Mounting is a breeze and the information gathered through shock travel can go a long way to perfecting your setup.
This box gives you a live remote mount display of your ignition timing as well as output wires to hook into your DataMaxx Data Logger. Easy to install and comes with your choice of straight, 45 degree and 90 degree TDC pickup sensors.
Being able to monitor what happens to the car down the track is extremely important, but so is being able to monitor what the driver did. Did you let off the throttle before or after the finish line? How much did you let off? How much mph did that kill? With the Throttle Position Kit you can finally monitor exactly what the driver did at the top end and increase your chances of reproducing successful results.
Replacement magnet for use in driveshaft, inputshaft and universal shaft RPM sensors.
This is a Replacement Driveshaft Sensor itself and does not come with any extension cables or mounts. Simply the 2 wire plastic driveshaft sensor.
This O2 Sensor Nut allows you to mount an oxygen sensor to any exhaust that the nut can be welded onto. The 8 x 1.5mm Weld-In Nut is only for mounting the O2 sensor on exhaust pipe. You can also purchase an optional O2 Sensor Plug if the sensor ever needs to be removed.
This O2 Sensor Plug mates with the 8 x 1.5mm weld-in nut and allows removing the sensor after tuning. Without this plug, removing your oxygen sensor will result in an open hole in your exhaust.
This is a standard Replacement Wide Band Oxygen Sensor to be used with a Daytona oxygen controller box. Includes only the sensor.
This 12′ Oxygen Sensor Extension Cable will allow you to extend the length between your actual oxygen sensor and the O2 controller. One side of the connecter is already terminated to fit the oxygen sensor. The other side is left open so that you can customize the length. We provide you with the Deutch connector and terminals that are easy to crimp with your standard crimpers, no specialty tools required.
These Wire Strippers are made specifically to strip those smaller gauge wires that most typical wire strippers can’t. The CAN Bus wire is a small 24 gauge wire, therefore we recommend all of our customers that have to connect a LCD, EGT, Expansion or Remote SD module use these wire strippers. Included in initial orders.
Out of stockFlow Meters allow you to determine exactly how much fuel you are pumping into your engine. Fuel pressure can give you a good idea but there is nothing more accurate than a flow meter for determine how much fuel is being pumped into your engine. The flow meters are available in three different sizes with different maximum gallons per minute for each.